Most RecentWhy does my transceiver RTL simulation fail to assert rx_is_lockedtodata when in internal serial loopback with Stratix 10 L/H-Tile, Arria® 10, and Cyclone® 10 GX devices?Why am I observing Design Closure Summary Fail In F-Tile IP Example Designs?Why does the PHY Lite for Parallel Interfaces IP Parameter Editor GUI not produce any error message when input or bidirectional pins are placed in the same lane as RZQ using POD I/O standards?Serial Lite IV FPGA IP designs must be manually upgraded to IP version 5.5.4 in the Quartus® Prime Pro Edition Software version 25.3Why am I experiencing compilation failures with the F-Tile Ethernet Hard IP design when the Ethernet mode is set to 25GE-1 variant and the FEC mode is configured as IEEE 802.3 RS(544,514)?Why doesn't the Triple-Speed Ethernet (TSE) FPGA IP for all devices always maintain a negative running disparity during idle cycles as per the IEEE 802.3 standard?Info: Your choice for adding mutual inductance in the output IBIS file is not satisfied, as the .pkg file is not foundCritical Warning(24567): The design is using an internal oscillator along with transceivers, EMIF, MIPI, and PHY Lite interfaces.Why does the F-Tile Triple-Speed Ethernet IP Design Example fail during simulation on Windows using ModelSim* in the Quartus® Prime Pro Edition Software version 24.3?Why does the F-Tile Triple-Speed Ethernet IP with core variation 10/100/1000 Ethernet MAC with 1000BASE-X/SGMII 2XTBI PCS and Embedded PMA Signals (F-Tile) drop packets?