Forum Discussion

Motaz_sami's avatar
Motaz_sami
Icon for New Contributor rankNew Contributor
2 months ago

U-Boot "Synchronous Abort" boot failure on Terasic Atum A5 Rev B via Quartus 24.3 .jic generation

I am reaching out for technical assistance regarding a reproducible boot failure on the Terasic Atum A5 Rev B development board (Agilex 5) when using Quartus Prime Pro 24.3. I am attempting to compi...
Arm Processor
general
Hps Boot
kbrunham_altera's avatar
kbrunham_altera
Icon for New Contributor rankNew Contributor
1 month ago

Hello,

24.3 is very early software for Agilex 5. I would strongly recommend updating to 26.1 and then using the validated ATF and Uboot ingredients from https://github.com/altera-fpga with the label QPDS26.1_REL_GSRD_PR

 

Motaz_sami's avatar
Motaz_sami
Icon for New Contributor rankNew Contributor
1 month ago

I was using 26.1 but had to downgrade to 24.3 to be able to use the Terasic GHRD because any other version causes a lot of issues with it 

  • KianHinT_altera's avatar
    KianHinT_altera
    Icon for Frequent Contributor rankFrequent Contributor
    1 month ago

    Dear Customer,

    We have not hear back from you and it has been idling for a while. We will continue to monitor this post for the next 5 days. If there are no further inquiries during this period, we will step back and allow the community to assist with any future follow-up questions.


    Thank you for engaging with us!

    Best regards,
    Altera Technical Support