Forum Discussion

xingyunzhidi's avatar
xingyunzhidi
Icon for New Contributor rankNew Contributor
10 months ago

The issue encountered when programming the POF file into MAX10

After powering on my FPGA development board, the power status LED did not light up, so I checked it and found that the issue was with the MAX10 chip. I then planned to reprogram the MAX10 using the m...
Configuration
Power
Programmable Logic Device
lixy's avatar
lixy
Icon for Contributor rankContributor
9 months ago

Hi Xingyunzhidi,


Are you using DK-DEV-AGI027-RA.? Please check the step 6 and 7 in this page: 3.5. Programming the Generated POF Image

JTAG ID code 0x020D10DD is the code of VTAP10.

After you connect the board to PC, open Programmer and then click "Auto Detect" to detect the current JTAG chain. As shown in the User Guide, normally you should would see VTAP10 in the chain instead of MAX 10 directly. So you need to follow the step 7: "Right click the VTAP10 device, Edit > Change Device, change it to MAX 10 > 10M50DAF256 ", click on MAX 10 device, then click "Change File" to add the factory image for MAX 10.


Best Regards,

Xiaoyan


xingyunzhidi's avatar
xingyunzhidi
Icon for New Contributor rankNew Contributor
9 months ago

Hi Xiaoyan

Actually, I have followed your description and replaced the VTAP10 with MAX10 as shown in the diagram, but I am still encountering this issue. Could you please help me understand why this is happening?