Forum Discussion

Sameer-sahu's avatar
Sameer-sahu
Icon for Occasional Contributor rankOccasional Contributor
2 months ago

Error (209014): CONF_DONE pin failed to go high in device 1.

I want to flash a simple led blink code bitstream file in Cyclone V E Dev kit using USB blaster. When I am trying to flash using USB blaster I am getting below error: Error (209014): CONF_DONE pin f...
Configuration
Core Logic
Generic Io
Programmable Logic Device
Sameer-sahu's avatar
Sameer-sahu
Icon for Occasional Contributor rankOccasional Contributor
1 month ago

Hi FakhrulA_altera​ ,
I have tried all the steps suggested by you. But still I am getting the same error. The DPI switchs are place by default attached in my previous message. How to check my JTAG is working or not?

FakhrulA_altera's avatar
FakhrulA_altera
Icon for Regular Contributor rankRegular Contributor
1 month ago

Hi,
 

We would like to check if there are any updates regarding this issue.

As we have not received a response to our previous follow-up, this thread will be transitioned to community support. We hope your concerns have been addressed.

Should you require further assistance, please feel free to open a new thread. Otherwise, community users may continue to assist here.


Thank you.