adding signal to debug/signaltap

Question

does quartus has something similar to Xilinx (*mark_debug=true), where it add the mark signal to FPGA internal logic anaylzer?

also how would i add signal to signaltap via command line? i'm assuming i need create and edit *.stp? but there are alot hierarchy so it hard to pinpoint the signal i want to add

sstrell · Answer

You add signals using the graphical .stp file. Just double-click in the Node List to open the Node Finder and add signals. If you are talking about post-fit signals, there is a "Preserve for debug" assignment in the Assignment Editor that marks signals so they are not optimized away during compilation.

As for adding signals from a command line? I don't see options for it:

https://docs.altera.com/r/docs/683819/26.1/quartus-prime-pro-edition-user-guide/signal-tap-command-line-options

Forum Discussion

adding signal to debug/signaltap

1 Reply

Recent Discussions

adding signal to debug/signaltap

SDM & Configuration Interface

Need Part EOL status(Active/Obsolete/Discontinued/NRND)

Agilex 7 JTAG Config Fails at 1% on Board #2 (Error 18950 / CONF_DONE Low) - But Board #1 Works

ECCN and HTS code for 1SX110HN2F43E2VG