Open Side Menu
Skip to contentAltera Community
Forums
BlogKnowledge BaseAltera.com
RegisterSign In
  1. Altera Community
  2. Knowledge Base
  3. All Articles
  • faq-help's avatar

    Why is the o_rx_pfc signal asserted incorrectly when using the F-Tile Ethernet Hard IP in 400GE mode?

    faq-help
    1 year ago
    105Views
    0likes
    0Comments
  • faq-help's avatar

    Why does the calculated VCO frequency of TX FGT PLL fractional mode in the IP Catalog GUI mismatch with the VCO frequency formula in the F-Tile Architecture and PMA and FEC Direct PHY IP User Guide?

    faq-help
    2 years ago
    186Views
    0likes
    0Comments
  • faq-help's avatar

    Why does rx_ready[i](i>0) of F-tile PMA/FEC Direct PHY FPGA IP tie to 0 when the number of PMA lanes is set to more than one and enabled per PMA lanes TX and RX ready signal?

    faq-help
    2 years ago
    226Views
    0likes
    0Comments
  • faq-help's avatar

    Why does the "Update Memory Initialization File" operation fail for an on-chip memory under a Platform Designer system?

    faq-help
    1 year ago
    145Views
    0likes
    0Comments
  • faq-help's avatar

    Why do I see a fitter error(21843) when bypassing RX auto adaptation for FGT channels by qsf assignments?

    faq-help
    2 years ago
    173Views
    0likes
    0Comments
  • faq-help's avatar

    What are the valid bits of the reconfiguration address bus to specify the selected channel when enabling the "Share reconfiguration Interface" option for the Transceiver Native PHY Arria® 10 FPGA/Cyclone® 10 GX FPGA IP

    faq-help
    3 years ago
    261Views
    0likes
    0Comments
  • faq-help's avatar

    How do I enable the electrical idle feature in the E-Tile Transceiver Native PHY Agilex® 7 FPGA IP?

    faq-help
    3 years ago
    233Views
    0likes
    0Comments
  • faq-help's avatar

    How do I install Cygwin for SoCEDS?

    faq-help
    3 years ago
    349Views
    0likes
    0Comments
  • faq-help's avatar

    Why does the Stratix® 10 EMIF Toolkit report DQS Enable Calibration failure?

    faq-help
    5 years ago
    271Views
    0likes
    0Comments
  • faq-help's avatar

    Why are Quartus® Prime Programmer versions 19.4 and 20.1 no longer available for download?

    faq-help
    2 years ago
    221Views
    0likes
    0Comments
Go to first page
Contact Us
Altera YoutubeAltera YoutubeAltera Twitter
  • Company Overview
  • Newsroom
  • Our Leaders
  • Careers
Subscribe to Altera Newsletter

© Altera Corporation | Terms of Use | Privacy Policy | Cookies | Trademarks | PSIRT

Altera Logo