Knowledge Base Article

Why does rx_ready[i](i>0) of F-tile PMA/FEC Direct PHY FPGA IP tie to 0 when the number of PMA lanes is set to more than one and enabled per PMA lanes TX and RX ready signal?

Description

Due to a problem in the Quartus® Prime Pro Edition Software version 24.1, rx_ready[i](i>0) of F-Tile PMA/FEC Direct PHY FPGA IP tie to 0 when the number of PMA lanes set to more than one and enable per PMA lanes TX and RX ready signal.

 

 

Resolution

To work around this problem in the Quartus® Prime Pro Edition software version 24.1, can monitor rx_lane_current_state[i][1] to instead rx_ready[i](i>0) status.

The problem has been fixed starting with Quartus® Prime Pro Edition software version 24.3.
 

Updated 3 months ago
Version 7.0
No CommentsBe the first to comment