Most RecentWhy are there ongoing DMA transactions at the Scalable Scatter-Gather DMA IP's device port even after the completion of the device port soft pause and soft reset sequence flow?Why am I seeing linkup problem when switching from DAC to AOC cable for the F-tile Ethernet Hard IP with Auto-Negotiation and Link Training (AN/LT) and Dynamic Reconfiguration enabled FHT designs.Is there a reference on how to enable internal serial loopback mode for the GTS Transceiver PMA link for usage with data rate < 7Gbps?Why do I see link failure after a few resets when the GTS Transceiver PMA link is placed under internal serial loopback mode?Why am I seeing a linkup problem when using consortium mode for F-tile Ethernet Hard IP with Auto-Negotiation and Link Training (AN/LT) and Dynamic Reconfiguration enabled designs?Why do o_tx_pll_locked and o_rx_is_lockedtoref toggle in simulation when using PMA clocking mode for Agilex® 3 and Agilex® 5 FPGAs in Quartus® Prime Pro Edition version 25.1.1 or earlier?Why does the o_tx_pll_locked signal of the GTS transceivers show an asserted state when there is no input reference clock for Agilex® 5 FPGA devices in the Quartus® Prime Pro Edition Software version 24.1 and 24.2?Why does a compilation error happen when using the IOPLL in the HVIO bank in place of a GTS System PLL for the PMA/FEC Direct PHY IP and all other protocol IPs for the Agilex® 3 FPGA and Agilex® 5 FPGA designs?Why are there errors while generating an example design using GTS Transceiver with Dynamic Reconfiguration (DR) between two rates in the Quartus® Prime Pro Edition software version 25.1?Why is the link-up failure observed for the F-tile Dynamic Reconfiguration Suite IP with Auto-Negotiation and Link Training (AN/LT) enabled designs when trying to skip Link Training (LT)?