Tse Phy Debug

Hi,

I just fired up our new custom board, and guess what, the network didn't start.

And I am in a hurry.

I have done a lot of work with phy's, but never via Nios. So could any of you gurus out there give me a few hint's?

When running the SSS example, and disabling the DHCP, the server starts.

The board is not connected to anything.

But when I try to read from 0x200 it returns ffff. And no activity on signal tap.

So:

How to get all the debug messages turned on?

And, has someone out there managed to get the loopback to work?

I assume that the mac has been initialized since the server reports ok.

I am about to start reading up on this, but it has been a while since I played with the fun stuff.

Thanks,

Apus