Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
15 years ago

TSE in 100MBit Mode

Hallo,

Could the TSE in SGMII Mode be used with 100 MBit Full Duplex and/or Half Duplex?

Can I force the Network Interface Card to either 100 MBit Full Duplex or Half Duplex and let the TSE core working with Auto Neg? Or do I have to change the register Settings?

Has anybody experience with this Core? or any ideas?

regards

Maybe for getting a feeling what my case is:

i have network card and a board with a Stratix IV GX on it. They both are connected via ethernet. And on my board the RJ45 connector is configured in SGMII Mode.

1 Reply

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    15 years ago

    hi,i'm also doing exercise about tse cor now, my kits is stratix iigx pcie,and i used mac with 1000 base -x/sgmii and pma(alt2gxb),and i want to use 100M mac ,i simulated with vwf, but i do not know whether it is right, and i do not know how to config the ff_tx_clk and ff_rx_clk, i see userguide,it says the ref_clk is 125M,but it does not define the quanta of ff_tx_clk about 10M/100M/1000M mac, now i'm troubling