Help with Altera DE2-115 8" LCD

Question

when running the demonstrations for the tpad i run into problems such as node "c0" is missing source file. I was wondering if anyone can help me better understand how to run the tpad demonstrations or even displaying text on the 8" LCD it would really help me out.

altera_forum · Answer

I don't know about tpad. But the error you got is apparently related to the pll where node "c0" is the pll output. I came across a similar error when the pll used had the "altpll" name in sopc. Just change the name a bit (by adding one or two characters) and recompile.

Hope this fixed your problem.

Forum Discussion

Help with Altera DE2-115 8" LCD

1 Reply

Recent Discussions

Can't generate F-Tile Ethernet Hard IP Design Example

Agilex 7 slew rate reconfiguration

Where is High Speed Transceiver Demo Design in FPGA Wiki ?

Avalon-MM Cyclone V Hard IP for PCI Express Intel FPGA IP Soft Reset and Hard Reset

Stratix 10 Transceiver PHY bonding and multiple TX PLL clock inputs (for DisplayPort TX)