Forum Discussion

Bachan's avatar
Bachan
Icon for New Contributor rankNew Contributor
2 months ago

Requesting you to resolve the programming on Cyclone V SX SoC Development Kit

Board: Cyclone V SX SoC Development Kit FPGA: 5CSXFC6D6F31 Quartus: Prime Lite 20.1 (Windows 11) JTAG Cable: USB-Blaster II Observed JTAG devices:   SOCVHPS   5M1270ZF324 Expected device missi...
Configuration
FvM's avatar
FvM
Icon for Super Contributor rankSuper Contributor
2 months ago

Hi,

sounds like you got SW4 settings wrong. Which devices are recognized in default JTAG setting, SW4 = off, off, on, off, JP6+7 installed? FPGA only should be SW4=on, off, on, on.

  • Bachan's avatar
    Bachan
    Icon for New Contributor rankNew Contributor
    2 months ago

    thank you for the response,

     I have checked for SW4 = off, off, on, off.it is showing the 5M1270, SOCVHPS and if I click auto detect, it is asking for select the device, I have selected(5CSXFC6D6) and confirm it. I have checked the JP6+JP7.

    after that,               

    I have done this, FPGA only should be SW4=on, off, on, on. I clicked on the auto detect, then it is showing this below error,

    unable to scan device chain. can't scan JTAG chain.do you want to open the JTAG chain debugger to troubleshoot the JTAG chain?

     

    can you please tell me what I have to do further.

     

    Best regards,

    Bachan

    • FvM's avatar
      FvM
      Icon for Super Contributor rankSuper Contributor
      2 months ago

      Hi Bachan,

      my answer was based on user manual and schematic. Unfortunately I don't have the board and can't help further. Altera support should take care for the problem.

      Regards Frank

    • FakhrulA_altera's avatar
      FakhrulA_altera
      Icon for Regular Contributor rankRegular Contributor
      1 month ago

      As we haven't received a response to our previous notification, this thread will be transitioned to community support. We hope all your concerns have been addressed. If you have any new questions, please feel free to open a new thread to receive support from Intel experts. Otherwise, community users will continue to assist you here. Thank you.