Forum Discussion
niranjandevarajan
New Contributor
New ContributorDAC Interface Instability After Migrating from MAX7000 to MAX10
Hi all, In one of our legacy designs, we used the MAX7000 (EPM7128AETC100-10N) CPLD. Due to obsolescence, we updated the design to use the MAX10 (10M04SCE144C8G). After the migration, we are observ...
Farabi_Altera
Regular Contributor
Regular ContributorHello,
Could you please share your setup, what has changed etc.
We need to know the IO voltage standard and power.
regards,
Farabi
niranjandevarajanNew Contributor
New ContributorHi Farabi,
Thanks for response
I have attached modified new setup with MAX10 and old working setup with MAX7000 images.
Old MAX7000 Schematic
Regards
Niranjan
AqidAyman_AlteraHi Niranjan,
As per my knowledge, our device does not have a DAC architecture, so there is no way for me to check this.
MAX 10 only have the ADC architecture. Refer below:
Regards,
Aqid
- AqidAyman_Altera
Hi Niranjan,
Please let us know if further assistance is needed for this issue.Regards,
Aqid
