Forum Discussion
ZhiqiangLiang
Occasional Contributor
Occasional Contributorconvert avalon bus to AXI4-Lite
Hi, My FPGA model is: Cyclone 10 LP 10CL120. I am now using Quartus II 18.1. In FPGA, I added NIOS II, and I would like to convert avalon bus to AXI4 LIte master. It means that NIOS will send ou...
RichardT_altera
Super Contributor
Super Contributor
ZhiqiangLiangThank you!
I have many questions to use Cyclone 10 LP 10CL120.
My company buy the FPGA, and produce the PCB board. however, we can't power on it.
For example, my questions are:
1) whether we should connect a crystal oscilator to which pin of FPGA.
2) how to use Quartus to constrain signal node to GPIO pins.
3) I would like to run NIOS II in FPGA, however I don't know how to enable burning firmware interface.
4) and etc.
Our product previously used ZYNQ7000 of Xilinx, but Now, we are going to use Cyclone10LP.
Would you please contact me by my email: [email protected].
By the way, I previously worked in Intel as well.
