SD Card Boot

Hi Malcolm,

I hope you have reprogrammed the new .jic image to QSPI before using the sd card image.

This .jic image is given on the same link-https://releases.rocketboards.org/2025.04/gsrd/agilex5_mk_a5e065bb32aes1_gsrd/

Please confirm.

Regards

Tiwari

Hi Tiwari,

Many thanks for your answer. After programming the QSPI with the image you suggested, I was able to boot linux successfully ( I believe from the SD Card!).

Please can you give a brief explanation as to why this was necessary? What was preventing linux from booting?

Many thanks

Malcolm

Hi Malcolm

This could be due to the mismatch in the hardware design.

For the the Hardware Design in the GSRD, it is HPS first configuration.

It is separated into initial configuration for the HPS and the core configuration of the FPGA.

The initial configuration is stored in the QSPI Image and the second configuration is in the SDCard.

For a normal boot, both configurations must be of the same build.

That could be the possible problem you are facing. I could not determine that without looking at the error from the bootlog.

Regards

Jingyang, Teh

Hi

Do you have any follow up question on this?

Regards

Jingyang, Teh

Hi Jingyang,

Thanks, I think that makes some sense but I will have to re-read the information about how the configuration scheme works - it is not like the Cyclone V SoC that I am used to!

When you mentioned looking at the bootlog, how can I do this if I don't get anything out on the serial port?

Thanks

Malcolm

Malcolm - Our architecture has changed quite a bit since Cyclone V! You may find the HPS Booting UG to be helpful.

Sue

Hi Malcom

In that case, if you do not get any serial output.

It is best to verify the boot binaries are generated properly or the boot related switches are toggled correctly.

If that does not work, we will need to debug it using the debugger.

Also as suggested in the previous comment, going through the boot user guide will be helpful too.

Regards

Jingyang, Teh

Hi

As we do not receive any response from you on the previous question/reply/answer that we have provided. Please login to ‘https://supporttickets.intel.com/s/?language=en_US’, view details of the desire request, and post a feed/response within the next 15 days to allow me to continue to support you. After 15 days, this thread will be transitioned to community support. The community users will be able to help you on your follow-up questions.

Regards

Jingyang, Teh

@JingyangTeh_Altera

I encountered the issue for 2025 and i switched to 2024.07 to confirm all basic function sanity.

Now i am switching back to settle the 2025.01 or 2025.04 issue on the boot for Cyclone V.

Same situation that after the message:

"

U-Boot SPL 2025.01-gcd3a9044d661-dirty (Sep 01 2025 - 08:57:07 +0800)
Trying to boot from MMC1

"

I had study short on that document and if not wrongly understand.

The A2 partition is no longer use?

The U-Boot is a must to use Jtag or QSPI or Flash based chip to store the 1st boot data?

It is possible to change to A2 partition like 2024.07?

Thank you

case reopening