Forum Discussion

Richard_P's avatar
Richard_P
Icon for New Contributor rankNew Contributor
2 years ago

NCONT ERROR in ACK for access 0 : ACK = 0x01 when trying to connect with Arm DS debugger through JTA

Hi, I am an embedded developer trying to help bring up a custom Arria 10 board. I can successfully load the SOF file to configure the FPGA using the Intel Quartus Prime Programming utility through a...
Hps Boot
aikeu's avatar
aikeu
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hi Richard_P,


I am closing this thread for now as I was unable to reproduce the issue on my side. Do consider to contact Terasic for any hardware related issue with Han Pilot board. This thread will be transitioned to community support. If you have a new question, feel free to open a new thread to get the support from Intel experts. Otherwise, the community users will continue to help you on this thread. Thank you.


Thanks.

Regards,

Aik Eu