Forum Discussion

Richard_P's avatar
Richard_P
Icon for New Contributor rankNew Contributor
2 years ago

NCONT ERROR in ACK for access 0 : ACK = 0x01 when trying to connect with Arm DS debugger through JTA

Hi, I am an embedded developer trying to help bring up a custom Arria 10 board. I can successfully load the SOF file to configure the FPGA using the Intel Quartus Prime Programming utility through a...
Hps Boot
aikeu's avatar
aikeu
Icon for Regular Contributor rankRegular Contributor
2 years ago

Hi Richard_P,


I will close this thread if no follow up.


Thanks.

Regards,

Aik Eu


  • Richard_P's avatar
    Richard_P
    Icon for New Contributor rankNew Contributor
    2 years ago

    Hi Aik,

    It looks like we were posting at the same time. I was asking in my post above yours to see if you can duplicate my error with an Arria 10 dev kit if you have access to one.

    Thanks,

    Richard