Forum Discussion

binupr's avatar
binupr
Icon for Occasional Contributor rankOccasional Contributor
2 years ago
Solved

Signaltap waveform display empty

Hi, I want to debug an Agilex SoC FPGA fabric with signal tap. I created the stp files with signals I want to probe. Created sof, programmed the FPGA via uboot. But I don’t see any thing on the wav...
Platform
  • binupr's avatar
    binupr
    2 years ago

    Thanks for the previous response.

    I narrowed down our issue. For some reason the Signal Tap enable command was not enabled in my generated TCL.

    You can close this ticket.

    Regards

    BPR

RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
2 years ago

Great! I'm pleased to know that you are to solve the issue.


Now, I will transition this thread to community support. If you have any further questions or concerns, please don't hesitate to reach out.


Happy Signal Tapping! It is a great tool to use.


Best Regards,

Richard Tan