Hi Everybody, I started using scripts for compiling and have the following problem: Using quartus_sh: How can I filter the information shown in MS-DOS? I only want to see Warnings, Errors and Critical Warnings. Maybe "Started Fitter" or such info would also be nice. quartus_sh --help was not helpful :-(

Perhaps you have already tried this but I would guess that the same techniques that one can use to suppress messages while in the Quartus development application would also work when using the shell commands. I have not tried that myself but would be interested to hear if this helps. See the ""Analyzing and Controlling Synthesis Messages" chapter in this part of the Quartus Handbook: http://www.altera.com/literature/hb/qts/qts_qii51008.pdf

You can use quartus_sh command with option -s!

Jerry, I do not understand how the -s option can be used to control the large number of info messages that quartus displays in the MS-DOS window while a compilation script. I did check into my suggestion above and it seems to have no impact on the messages produced, so it may be disregarded. Seems like the best ways to check warnings and errors are either to open up the project in the quartus IDE and look at the compilation report or to have the tcl script parse the compilation report and sort out the non-suppressed messages of the desired levels. So far, I normally have the tcl script check the worst case slack and some other key parameters and then use the quartus GUI to scan for warnings.

Hi mvanpelt, You are right, you should write script to read the report from the rpt files after compilation. The -s options just can pause the ms-dos when the compilation is completed.

open Nios II Command Shell. run: quartus_sh --flow compile project.qpf | grep Warning

Scripting and Options for quartus_sh | Altera Community

13 Replies

Altera_Forum
Honored Contributor
12 years ago
--- Quote Start ---
as mentioned above, you can use the Nios II Command Shell on Windows, which is actually a cygwin terminal. cygwin includes grep
--- Quote End ---

Thanks for you reply！

Now, i can extract the information from the compilation reports thru using grep or using tcl codes.
Altera_Forum
Honored Contributor
12 years ago
Thank you very much for your posts! Actually I forgot to check the posts after getting the first one.

The idea with the Nios Shell was good. But unfortunately my script is in batch and I don't want to change to linux scripting.

I will try to use the code from Jerry
Altera_Forum
Honored Contributor
12 years ago
--- Quote Start ---
Thank you very much for your posts! Actually I forgot to check the posts after getting the first one.

The idea with the Nios Shell was good. But unfortunately my script is in batch and I don't want to change to linux scripting.

I will try to use the code from Jerry
--- Quote End ---

Hi vhdl_world,

When you use the code, please note which only extract map's warning informations. Becasue different warnings are strored in different rpt files, so if you want to extract full compilation's warning info you should open all different rpt files and extract what you want from them.

Forum Discussion

Scripting and Options for quartus_sh

13 Replies

Recent Discussions

timing violation fix

Issues with downloading

Quartus Prime Lite 25.1 License Error - "Unable to checkout a license" (SALT_LICENSE_SERVER)

Quartus Prime Pro 26.1 - Where to find Documentation of new Signaltap features

Error (292014): Can't find valid feature line for core SLL_CA_HBC_T001_Hyperbus_Memory_Controller_10