Forum Discussion
MichaelB
Occasional Contributor
Occasional ContributorPlan error after upgrading Quartus Pro version 20.4 to 22.4
Hi, I just upgrade my project for a Stratix 10 MX FPGA from 20.4 to 22.4. With 20.4 the design run was successful but after upgrading to 22.4 I see planning errors with the same RTL / IP set: ...
vkaprasath
New Contributor
New ContributorHello,
Is there any resolution for this case ?
I'm also getting similar error when migrating my design from Quartus prime 18.3 to Quartus prime pro 23.4.
Below is the screenshot which shows the error during fitter stage.
Please let me know which causes this failure.
Regards,
Prasath
