Forum Discussion

OJin0's avatar
OJin0
Icon for Occasional Contributor rankOccasional Contributor
5 years ago

New Project: Logics_Suite,

Simulation cannot be performed due to the message "Iteration limit 50000 reached". Thank you.
  • RichardT_altera's avatar
    RichardT_altera
    Icon for Super Contributor rankSuper Contributor
    5 years ago

    I would recommend to use Modelsim for your simulation as I able to do so without error.

    • OJin0's avatar
      OJin0
      Icon for Occasional Contributor rankOccasional Contributor
      5 years ago
      Hello, thanks for helping me. I am not using Modelsim yet. So I use Simulation Waveform Editor. I did the simulation again in the Simulation Waveform Editor today, but the error message opens like the attached picture. I hope you simulate it in the Simulation Waveform Editor. Thank you.
    • OJin0's avatar
      OJin0
      Icon for Occasional Contributor rankOccasional Contributor
      5 years ago

      Hello, thanks for helping me.

      I am not using Modelsim yet.

      So I use Simulation Waveform Editor.

      I did the simulation again in the Simulation Waveform Editor today, but the error message opens like the attached picture.

      I hope you simulate it in the Simulation Waveform Editor.

      Thank you.

    • RichardT_altera's avatar
      RichardT_altera
      Icon for Super Contributor rankSuper Contributor
      5 years ago

      I have request the engineering team to look into this whether this error message can be suppressed or configure the setting.

      May I know which Quartus version are you using?

      Fyi, you can download and learn to use our ModelSim*-Intel® FPGA Edition tool in our https://fpgasoftware.intel.com webpage.