Forum Discussion

MohdAnnuar_S_Intel's avatar
MohdAnnuar_S_Intel
Icon for New Contributor rankNew Contributor
6 years ago

How to solve unexpected error in JTAG server -- error code 35?

This is seen on Windows Quartus prime pro version 17.1 programmer via USB Blaster II cable. I am trying to program FPGA on stratix 10 GX development board.
ShafiqY_Intel's avatar
ShafiqY_Intel
Icon for Frequent Contributor rankFrequent Contributor
6 years ago

Hi MSuha1,

I'm apologize for late reply.

Here's the comment from my colleague:

" I found that this "error code 35" was caused to due to a network issue at the customer's end. Turning off the network switch helped to program the board successfully."

I hope this will help you to move forward.

Thanks

MohdAnnuar_S_Intel's avatar
MohdAnnuar_S_Intel
Icon for New Contributor rankNew Contributor
6 years ago

Thank you for the follow up. We have tried turning off the network connection but the problem persists. However, we found out that the FPGA chip we have on board is different from our counterpart who generates the FPGA image. They seems to have the Engineering release version while we have the released version.

  • ShafiqY_Intel's avatar
    ShafiqY_Intel
    Icon for Frequent Contributor rankFrequent Contributor
    6 years ago

    Hi MSuha1,

    May I know the status of this issue?

    Thanks

  • MohdAnnuar_S_Intel's avatar
    MohdAnnuar_S_Intel
    Icon for New Contributor rankNew Contributor
    6 years ago

    FPGA team facing issue regenerating IP FPGA image on this specific FPGA chip. We are aligning the FPGA HW version with FPGA team so that we won't hit this issue again.

    Thanks