Forum Discussion
Honored ContributorDE0-NANO and Qsys : error when quit Qsys tools
Hi,
I begin to use Quartus 15.0 and Qsys. I want create a ADC project. I use Qsys tools. I put CPU : Nios II (Classic) Processor. When I quit Qsys tools, i have this error (I didn't generate): http://www.alteraforum.com/forum/attachment.php?attachmentid=11436&stc=1 I try to finish my Qsys project and i have the same error. Thanks for your help Jennifer16 Replies
Altera_Forumcan i confirm did you install the quartus with the default installation folder?
- Altera_Forum
Your project won't work unless you 'Generate'.
The message - which is not an error message - is simply stating that you need to add files to your Quartus project. In Quartus, under 'Project' -> 'Add/Remove Files in Project', add those files to your project. Cheers, Alex - Altera_Forum
HI,
Thanks for your interest about my problem. 1) I installed with default folder 2) I didn't have this files .qip and .sip Thanks for your help Jennifer - Altera_Forum
Hi,
I tested with 14.1 version and i have the same error Best regards Jennifer - Altera_Forum
As said by Alex, this is not an error. Everyone sees this when exiting QSYS after creating a system. You need to successfully generate the QSYS system before the qip file is created. The qip file is created in a directory with the same name as your QSYS system. If you are using windows, the find file feature can locate if for you, just search for *.qip. In order to have the QSYS system included in your quartus project, you need to add the file as Alex mentioned.
- Altera_Forum
yea. did you try generate first before you quit? see it that window still pop?
- Altera_Forum
Check your directory: C:/altera/Jennifer/DE0_NANO_ADC/DE0_NANO/synthesis/DE0_NANO.qip
The above is the default path to the DE0_NANO.qip. The <generation_directory> can change according to your selection during generation. The message is to prompt you to include the DE0_NANO.qip file into Quartus for compilation purpose. - Altera_Forum
Hi,
I must begin because i have 2 erros in "System Contents" of Qsys Error: unsaved.nios2_qsys_0: Reset slave is not specified. Please select the reset slave Error: unsaved.nios2_qsys_0: Exception slave is not specified. Please select the exception slave I find the solution from Gruß Tobi you need to specifiy the reset and exception address. Open the Nios II Processor and set the reset and exception vector at the first tab. I don't undestand because i use nios2_Qsys_0.jtag_debug_module for Reset Vector and Exception Vector !!!!!!!! Thanks for your help Jennifer - Altera_Forum
Hi,
I have still the first problem from my post but not too bad. i pu "Absolute" for Reset Vector and Exception Vector. and after, i put the memory. I haven't errors. Best regards Jennifer - Altera_Forum
Regarding to the error for reset and exception slave, you will need to connect to an actual memory, either a onchip_memory or DDR. You must not set the reset/exception slave to the jtag_debug_module because that interface is used as for break or debugger operations only.
You can put absolute values but you need to make sure that there is valid memory corresponding to the absolute value. Usually by design, once you connect a memory to the instruction master, you should be able to select the reset/exception slaves via the drop down box. Maybe you can refer to the following document: https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/tt/tt_nios2_hardware_tutorial.pdf
