SOPC (or project) for ucLinux on 4sgx230 (Stratix IV GX FPGA Development Board)

Hi

I have been trying to get uClinux to boot on my project, which is pretty close to triple_speed_ethernet_design for the same board (tserd_4sgx_230_sopc.sopc). It does not go further than:

"Uncompressing Linux... ok, booting the kernel\n".

I think I have some wrong hw config but cannot figure it out.

It would be easy if I have a working sopc for that board that is tested with ucLinux so I can test and compare it with my project, any help will be appreciated.

BTW, all other nios-ii software including the simple_socket_server work fine on the system.