Forum Discussion

sittinhawk's avatar
sittinhawk
Icon for New Contributor rankNew Contributor
5 months ago

JTAG_UART stuck in printf

I'm trying to setup a NiosV and have printf appear over the JTAG_UART. I've used only the default settings when generating the bsp (just the generate command, no set_settings). I notice when I debug,...
general
sittinhawk's avatar
sittinhawk
Icon for New Contributor rankNew Contributor
5 months ago

This is how I created the BSP: In Quartus, Platform Designer, File -> New BSP, this generated the file "settings.bsp", and then I ran the command "niosv-bsp.exe -g settings.bsp"

BoonBengT_Altera's avatar
BoonBengT_Altera
Icon for Moderator rankModerator
4 months ago

Hi sittinhawk,

As we do not receive any further clarification/updates on the matter, hence would assume challenge are overcome. We will continue to monitor this post for the next 5 days. If there are no further inquiries during this period, I will step back and allow the community to assist with any future follow-up questions.

Thank you for engaging with us!

Best regards,
BB