Forum Discussion

Oliver_I_Sedlacek's avatar
Oliver_I_Sedlacek
Icon for Contributor rankContributor
3 years ago

Debugger wont connect to NIOS II hello world on Cyclone GX development board

The Cyclone 10GX seems to configure from the programmer but Eclipse fails to connect though the embedded download cable. I only got this far by checking the 'Ignore mismatched system ID' and 'I...
Embedded Applications Layer
wwanalim_intel's avatar
wwanalim_intel
Icon for Contributor rankContributor
3 years ago

Hi,


Do you have any updates to share about this issue?


Oliver_I_Sedlacek's avatar
Oliver_I_Sedlacek
Icon for Contributor rankContributor
3 years ago

My evaluation board was refusing to configure so I haven't been able to try anything (see https://community.intel.com/t5/FPGA-SoC-And-CPLD-Boards-And/Is-my-Cyclone-10-GX-development-kit-board-faulty/m-p/1544844/emcs_t/S2h8ZW1haWx8dG9waWNfc3Vic2NyaXB0aW9ufExQMjhJS05NSjZaWFBYfDE1NDQ4NDR8U1VCU0NSSVBUSU9OU3xoSw#M26394)

It configured this morning so I'll see if I can make any progress with the NIOS.

I did the NIOS platform from scratch because I've never found an example that didn't need a load of changes just to get it to compile with my installed version of Quartus. I've been using the Trenz Cyc1000 NIOS with reasonable success apart from booting from off chip memory, https://community.intel.com/t5/Programmable-Devices/Autostart-NIOS-from-external-SDRAM-problem/m-p/1509971#M91900 which I just gave up on.