VIP: Designing own components - possible?

Question

Hi,

I'm very interested in using the VIP Suite. I've got a general question: Is it possible to design own components, like an own Testpattern Generator or similar...

I asked because I don't know yet how to integrate my own components to the others for example. Is there any sheet where the information flow of the din and dout connectors of the VIP components is described for example? Or how does it work to design own components for an existing suite?

Thanks for giving me a short overview!

Best regards,

dbdeset

altera_forum · Answer

Yes, it is possible. I've done it already. Just look at Altera website -- there is many information about this (Avalon Master/slave, Streming interface ...) It is very tricky but it works.  Kest

altera_forum · Answer

between the Avalon Interface Specifications:

www.altera.com/literature/manual/mnl_avalon_spec.pdf

and the VIP Suite User Guide:

http://www.altera.com/literature/ug/ug_vip.pdf

you should have all the information required

altera_forum · Answer

Ok, thanks for your suggestions!

Forum Discussion

VIP: Designing own components - possible?

3 Replies

Recent Discussions

What Bank Mode of LPDDR5 does Agilex 5 support?

What is source clock of rx_core_clkout of Serial Lite IV IP

Confusion for TX Clock direction for Triple Speed 1G Ethernet IP?

Agilex 5: Connecting multiple AXI Masters to DDR without explicit Interconnect IP

Behavior of 10 GX Avalon-MM Interface for PCI Express* IP Core when byteenable=16'h0000