Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorTSE_MAC error
Hello all: I'm building a cyclone III custom board integrating a GigabitEthernet interface. In SOPC builder I have the TSEMAC connected to a SGDMA_TX and a SGDMA_RX. When running the simple_soc...
Altera_ForumHonored Contributor
Honored ContributorIf the software is the same and You get the error to this one - then I would say it's a hardware problem. But I am pretty sure it's software issue. Well, basically, not software, but probably fpga logic if You use channels for ethernet packets in Avalon-ST interconnect.
