Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Stratix IV DDR3 memory controller with Unify : simulation not working

Hello. I have a problem using DDR3 memory controller with Unify on Stratix IV. I use modelsim SE 6.5d or 10.0. My problem is that the controller is not working both with my design and Al...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

Hi,

I'm experiencing what appears to be the same problem on a Cyclone V using the DDR3 hard memory controller.

Based on dates, I assume that everyone above has found a solution. What is the solution?? It feels like the controller is being held in reset somehow but it's not obvious.

Any help appreciated.