Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

long simulation times when simulating UniPHY-based DDR3 in skip calibration mode

Hi, all According to this article at emi_debug.pdf on page 8: Table 1–1. Typical Simulation Times Using UniPHY IP, skip calibration should take only 3 minutes. My DDR3 UniPHY design is very ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

--- Quote Start ---

Also, may i know what is line limitations mean? For ModelSim Altera Starter pack, the line limitation only up to 10k.

--- Quote End ---

It means after 10000 lines of code, the simulation goes very very slow.