Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

long simulation times when simulating UniPHY-based DDR3 in skip calibration mode

Hi, all According to this article at emi_debug.pdf on page 8: Table 1–1. Typical Simulation Times Using UniPHY IP, skip calibration should take only 3 minutes. My DDR3 UniPHY design is very ...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

My computer spec is as below:

1. RAM : 8GB

2. Processor: Inter(R) Core (TM) i5-4210M CPU @ 2.6GHz 2.6GHz

3. Window: 64 bit OS Windows 7 Professional SP1

For modelSim model, I use ModelSim Altera Starter edition 10.3c