Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

InterNiche driver with Marvel 88E1111

good day. [recapitulation from other thread] i am using the cyclone iii development board (ef3c120f7807cn) the samples included in the dev kit does not include any ethernet. therefore...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
16 years ago

Hi rubenc,

I try ethernet marvell 88E1111 InterNiche in EP3C120F780, but in thread http://www.alteraforum.com/forum/showthread.php?t=3665&page=1

it use cyclone EP3C25.

it seem different component like dram, flash, and sram. so it will different in pin mapping.

How are you configure pin in file .qsf ?

if you don't mind can you post here your new design ethernet and how it configured.