Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

DSP Builder not recognizing Fixed Point Toolbox License

Hi I recently installed DSP Builder and upon simulating an Design using the advanced Blockset, I realized that my Matlab license is missing the Fixed-Point Toolbox. However, after installing sa...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
13 years ago

The ver output you showed says "Fixed-Point Toolbox Version 3.4 (R2011b)". I don't think this is the same as "Simulink Fixed Point".

Trust me, the error message you listed is not from DSP Builder. It's from Simulink. DSP Builder is trying to set the type of one of its ports to fixed point and Simulink is denying it because a license is missing.