configure the triple speed ethernet register with verilog

Question

Hello! I am using TSE(triple speed ethernet) ip core to implement communication bewteen my pc and the FPGA board(cyclone IV). But I don't know how to configure the TSE register with verilog. I do read some information from the user guide. For example, here are from the user guide:

Base registers to configure the MAC function. At the minimum, you must

configure the following functions:

• Primary MAC address (mac_0/mac_1)

• Enable transmit and receive paths (TX_ENA and RX_ENA bits in the

command_config register)

But I don't know how to realize this configuration in my quartus II project with verilog.

Anything can be help!

Best wishes!

altera_forum · Answer

Hi, Register &amp; Go through the “Implementing the Triple-Speed Ethernet MegaCore Function” training material for the detail stepwise solution, https://www.altera.com/support/training/course/otse1116p2.html  Also, refer the design example &amp; Intel FPGA Triple-Speed Ethernet IP Core User Guide &amp; try at your end.  https://www.altera.com/support/support-resources/design-examples/intellectual-property/embedded/nios-ii/exm-tse-sgdma.html https://www.altera.com/content/dam/altera-www/global/en_us/pdfs/literature/ug/ug_ethernet.pdf   Let me know if this has helped resolve the issue you are facing or if you need any further assistance.  Best Regards Vikas Jathar  Intel Customer Support – Engineering (Under Contract to Intel)

Forum Discussion

configure the triple speed ethernet register with verilog

1 Reply

Recent Discussions

Error when simulating F-tile Ethernet example design

Avalon Transaction Responses & Bridges

SerialLite II license for Arria10 FPGA

Agilex3/5 GTS Hard Ethernet IP 10G example design pin loc and io std wanted

CORDIC ATan2 Failed to Generate