Cannot run program "vsim"

Question

Hi,

When I try to verify a demo design in DSP Builder, I am getting the following error:

"Cannot run program "vsim":....The system cannot find the file specified".

But I have set the path of vsim.exe in the "File\Set Path" of MATLAB window. I can open the Modelsim by typing the command vsim.exe from the directory where it is present through the command window.

If I type vsim in the MATLAB window, it says "undefined variable or function".

Can anyone please help regarding this?

Thanks.

altera_forum · Answer

is it set in your system path?

altera_forum · Answer

Thanks for the reply.  Do you mean in the Environment Variables?  I set the following: Variable: vsim Value: C:\altera\12.0\modelsim_ae\win32aloem

altera_forum · Answer

Thanks Tricky. I could able to run it now.

altera_forum · Answer

hai visuma, i'm also facing the same problem. how did you rectify the issue???? regards nandak

altera_forum · Answer

I just set the path in MATLAB and also added the vsim path in System Environment Variable "Path".

Forum Discussion

Cannot run program "vsim"

5 Replies

Recent Discussions

Agilex-7 MSI-X missing om AXI MCDMA for PCIe

Agilex-7 AXI MCDMA for PCIe hang

agilex 7 Platform Designer PIO addr width

Direct RF ip

Agilex 7 R-Tile PIPE Direct Mode: Raw Rx Data Misalignment - Is Soft Word Alignment Needed?