Forum Discussion

JackMyers's avatar
JackMyers
Icon for New Contributor rankNew Contributor
3 years ago

USB-Blaster will not program in Quartus Prime Programmer Lite

I can connect my USB-Blaster and select it in the hardware setup however when I try to program my device (10M02SCU169) it identifies the JTAG chain but fails the programming operation at 4% progress....
Configuration
Programmable Logic Device
WZ2's avatar
WZ2
Icon for Frequent Contributor rankFrequent Contributor
3 years ago

Hi there，

I see your conversation. The experience on the other PC proves that your board and usb blaster are both good. In my opinion, there are three points:

1. Make sure your “error PC”’s usb port are good. Please Try to change the port.

2. In your “error PC”, open the “task manager” and try to kill the progress of “jtagserver” and do the program again.

3. Try to slow down the frequency of JTAG on your “error PC”.

Best regards,

WZ