UFM Status Register Read Successful for burst reads?

Question

I am doing burst reads to the UFM and I was wondering if (bit 2) in the UFM status register reports when a burst read is finished or if this after each read.  I am programming a MAX10.  -Chuck

altera_forum · Answer

Refer to Table 11 on page 24 of the 'max 10 user flash memory user guide (https://www.altera.com/en_us/pdfs/literature/hb/max-10/ug_m10_ufm.pdf)'. Bit 2 will only be set following a successful read.  Cheers, Alex

altera_forum · Answer

--- Quote Start ---

Refer to Table 11 on page 24 of the 'max 10 user flash memory user guide (https://www.altera.com/en_us/pdfs/literature/hb/max-10/ug_m10_ufm.pdf)'. Bit 2 will only be set following a successful read.

Cheers,

Alex

--- Quote End ---

Thanks Alex.

Forum Discussion

UFM Status Register Read Successful for burst reads?

2 Replies

Recent Discussions

Quartus Prime Pro 25.1 fatal error during fitter: Windows "Efficiency mode" required

Inquiry regarding purchasing FPGA licenses

Cyclone 10 LP's Extended Industrial parts

Agilex 7 F/I Series True Differential Input Termination

Agilex 7 F Series Transceiver Pins Allowed Voltages During Powerup/When Unpowered