Forum Discussion

Yt_aem's avatar
Yt_aem
Icon for New Contributor rankNew Contributor
3 years ago

Signal Tap Start-up failure

Hi,

I am using Quartus Prime Pro 19.1 and device is Cyclone 10GX150.

Using SFL to program the device is successful over the JTAG (See attached SFL.png). But, when opening the Signal Tap, it keeps saying, "Program the device to continue" (See attached Signal_tap.png). I have checked all parts related to JTAG and they are all correctly installed, consistent with the schematic attached.

Is there anyone who can help? I am in tight timing of a project.

Very very appreciate for your helps.

23 Replies

Show More
  • RichardT_altera's avatar
    RichardT_altera
    Icon for Super Contributor rankSuper Contributor
    3 years ago

    I don't see a .sof file in the JTAG Chain Configuration window (right hand side of Signal Tap).

    You need to browse and add the .sof file, then click the programming button (the one with a down green arrow) to program the device.

     

    Best Regards,

    Richard Tan

    p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.

    • Yt_aem's avatar
      Yt_aem
      Icon for New Contributor rankNew Contributor
      3 years ago

      It still fails.