Forum Discussion

Yt_aem's avatar
Yt_aem
Icon for New Contributor rankNew Contributor
3 years ago

Signal Tap Start-up failure

Hi, I am using Quartus Prime Pro 19.1 and device is Cyclone 10GX150. Using SFL to program the device is successful over the JTAG (See attached SFL.png). But, when opening the Signal Tap, it keep...
RichardT_altera's avatar
RichardT_altera
Icon for Super Contributor rankSuper Contributor
3 years ago

I don't see a .sof file in the JTAG Chain Configuration window (right hand side of Signal Tap).

You need to browse and add the .sof file, then click the programming button (the one with a down green arrow) to program the device.

 

Best Regards,

Richard Tan

p/s: If any answer from the community or Intel Support are helpful, please feel free to give best answer or rate 4/5 survey.

Yt_aem's avatar
Yt_aem
Icon for New Contributor rankNew Contributor
3 years ago

It still fails.