Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

please small help

hi i need a please small help.

i have here a board whit a cyclone 2 and i wand a make a dump whit the quartus but i dont no how i must do it.

plase cane sambody help me.:eek:

12 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    can you tell us which board exactly you have?

    also tell us, which sample code did you compile?
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    the oreginal circuit is a satelite decoder.

    -ep2c5t144c8n

    -24c64

    only i wand read the cyclone i have a dump of 24c64

    and later wirte the soft in a blank board.

    please help.
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    sure

    do you know how to use QuartusII programmer?

    launch the program from QuartusII tools menu.

    and connect to your USB-Blaster to your board.

    if you use Active Serial programming.

    check Examine flag and start it.

    you can read pof image from your FPGA(EEPROM)

    if you use JTAG, tell me that it need another skill.
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    hi my friend:

    i have a handmake jtag via ltp1 (bytblaster mv)

    is thas ok???????
  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    14 years ago

    A 24C64 (8 kByte) isn't able to store the configuration of EP2C5 (about 150 kByte), also it's not a supported configuration device. Your circuit most likely contains another programmable device, either memory or microcontroller with flash, that holds the configuration.