Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

Output Pin Driving Another Output Pin

Hello all, I've run into an unusual problem. I'll start off by describing my goal: I'm designing a circuit that can test for short circuits and open circuits in a wiring harness. The wiring har...
Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
14 years ago

--- Quote Start ---

Simply move to to the receiver end the resistor which pulls up to +12V.

Leave on driver end only the MOSFET. Sorry I was not clear on this point.

--- Quote End ---

Could you please elaborate on this bit? WHere should I move the resistor too on the receiving end?