How to register DSP builder 13.1 blockset in MATLAB2012b?

Question

I have installed both MATLAB2012b and DSP builder13.1 (both compatible), but the standard blockset does not show up in the simulink library. Any help will be much appreciated.

altera_forum · Answer

Hi,

Are you launching MATLAB directly?

You should use script to launch.

Start MATLAB.
Run the set-up script by typing the following at the MATLAB prompt:

Check the link

https://www.altera.com/support/support-resources/intellectual-property/dsp/dsp-builder/ips-dsp-builder-faq.html

Best Regards,

Anand Raj Shankar

(This message was posted on behalf of Intel Corporation)

Forum Discussion

How to register DSP builder 13.1 blockset in MATLAB2012b?

1 Reply

Recent Discussions

Trouble Getting started with Stratix 10 SOC

Timing Behavior of Remote Update IP After Reset on Cyclone 10 GX (10CX150YF672E5G)

Agilex 7 F Series Transceiver Pins Allowed Voltages During Powerup/When Unpowered

License Server new License File

Does the 1SG280LU2F50E2VG support bitfile encryption