Forum Discussion

Matthew99's avatar
Matthew99
Icon for New Contributor rankNew Contributor
1 year ago

how to perform FW update with *.jed_enc on MAX 10

Hi experts,

I am not familiar with Alter FPGA.

We use Altera MAX 10 device on our PCB board, there is cpld firmware file *.jed_enc.

how to perform the cpld firmware update? if the MAX CPLD is used at server PCB, any expert know how to update cpld fw via redfish?

Thanks

Programmable Logic Device

3 Replies

  • Farabi's avatar
    Farabi
    Icon for Regular Contributor rankRegular Contributor
    1 year ago

    Hello,


    First you need to find the 10-pin JTAG port on your board. Then you need to have USB Blaster II programming cable. Then you will be able to program the MAX10 FPGA.


    regards,

    Farabi


    • Matthew99's avatar
      Matthew99
      Icon for New Contributor rankNew Contributor
      11 months ago

      Hi @Farabi

      Sorry for the late reply.

      For Altera MAX 10 FW update, in addition to use USB Blaster II programming cable, what kind of software I need to install?

      is there any document?

      Since I need to update CPLD FW via Redfish, clinet to push CPLD FW to specific URI, then device copy to /tmp folder.

      Now the CPLE FW is under /tmp folder, how to perform CPLD FW update?

      write image to specific location?

      any suggestions

      Thanks

  • FakhrulA_altera's avatar
    FakhrulA_altera
    Icon for Regular Contributor rankRegular Contributor
    1 year ago

    As we haven't received a response to our previous notification, this thread will be transitioned to community support. We hope all your concerns have been addressed. If you have any new questions, please feel free to open a new thread to receive support from Intel experts. Otherwise, community users will continue to assist you here. Thank you.