Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorHelp me about measure clock on osciloscope.
Hi everyone, I have project on board DE2. I use PLL in megafunction to create the clock 500MHz from 50MHz. Then i use clock counter to decrease the clock from 500MHz to clock_out 250KHz, 125KHz, 6...
Altera_ForumHonored Contributor
Honored ContributorGPIO signals can be seen in a oscilloscope.
However, anything faster than a few tens of MHz is going to be seriously distorted. Tricky was asking you if you have run your design though TimeQuest to make sure it works correctly with the clocks.
