Forum Discussion
Altera_Forum
Honored Contributor
Honored ContributorERROR with programer
Hello everyone, i have trouble with programing of my EP3C16Q240, i have my own board (schematic is in attached PDF). If i use USB blaster, quartus 9.0 says this: Info: Started Programmer operat...
Altera_ForumHonored Contributor
Honored Contributoryes, i have 10k between msel and gnd, i try connect msel to ground without resistors. Flash memory isnt on board now, i fill only jtag connector and of course resistor on others signals like confdone, nce, etc. It means i have there almost everything without flash memories
