EPCS selection for Cyclone 10 FPGA

Question

I have a design that amounts to roughly 8000 Logic elements and need help in choosing an appropriate EPCS device so that it turns out cheapest and less area consuming on board.

The size of which file defines the capacity of EPCS to be selected?

Thank you in advance!

shafiqy_intel · Answer

Hi NShan12,Usually we determine the size of the configuration device based on Uncompressed Configuration Bit Stream Size of our design. You can refer to Cyclone 10 datasheet for this details (page 53, table 54):https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10gx-51002.pdf#page=53Thanks

nshan12 · Answer

Thank you @ShafiqY_Intel​

Forum Discussion

EPCS selection for Cyclone 10 FPGA

2 Replies

Recent Discussions

Agilex 3 PLL in Source Synchronous mode ?

RSU: How to handle FACTORY_IMAGE signing and trust validation?

Cyclon 5 tampering protection bit

EP4CE22F 256 net length report not found

MSEL and nCONFIG behavior at power up