Forum Discussion

Occasional Contributor

6 years ago

EPCS selection for Cyclone 10 FPGA

I have a design that amounts to roughly 8000 Logic elements and need help in choosing an appropriate EPCS device so that it turns out cheapest and less area consuming on board. The size of which fi...

ShafiqY_Intel

Frequent Contributor

6 years ago

Hi NShan12,

Usually we determine the size of the configuration device based on Uncompressed Configuration Bit Stream Size of our design.

You can refer to Cyclone 10 datasheet for this details (page 53, table 54):

https://www.intel.com/content/dam/www/programmable/us/en/pdfs/literature/hb/cyclone-10/c10gx-51002.pdf#page=53

Thanks

NShan12

Occasional Contributor

6 years ago

Thank you @ShafiqY_Intel

Forum Discussion

EPCS selection for Cyclone 10 FPGA

Recent Discussions

Cyclone-V SCFIFO - adding ECC to M10K/MLAB/Auto memory

Will serialization factor of 6 in LVDS serdes IP be supported in the future on Agilex5?

System PLL of Agliex5 PCIE example design cannot be locked after configuration

JTAG Chain Broken on Agilex 7-I Dev Kit

Request for Cyclone V Pinout File Information