Forum Discussion

Altera_Forum's avatar
Altera_Forum
Icon for Honored Contributor rankHonored Contributor
11 years ago

display net names

I can not seem to figure out how to determine the name of a net on a schematic. I tried properties and all get is font settings. I get error messages that refer to a net but can not find the net

2 Replies

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    11 years ago

    Been a while, but can you right-click Locate on the error and it highlights the net?

  • Altera_Forum's avatar
    Altera_Forum
    Icon for Honored Contributor rankHonored Contributor
    11 years ago

    --- Quote Start ---

    Been a while, but can you right-click Locate on the error and it highlights the net?

    --- Quote End ---

    when I click on the error it takes me to the device. This is good. But all i want to see is the net names. I found an obscure post that indicated that there was an option

    menu somewhere where you simply set an option to have net names displayed on the schematic. But I can not find the display option panel.