Forum Discussion
Altera_Forum
Honored Contributor
Honored Contributordisplay net names
I can not seem to figure out how to determine the name of a net on a schematic. I tried properties and all get is font settings. I get error messages that refer to a net but can not find the net
Altera_ForumHonored Contributor
Honored Contributor --- Quote Start --- Been a while, but can you right-click Locate on the error and it highlights the net? --- Quote End --- when I click on the error it takes me to the device. This is good. But all i want to see is the net names. I found an obscure post that indicated that there was an option menu somewhere where you simply set an option to have net names displayed on the schematic. But I can not find the display option panel.
