Forum Discussion
t_alars
New Contributor
New ContributorCyclone V GS power estimation
Hello All, I have a 10 years old project with Cyclone 3 and Quartus 10, and now I will migrate it to Cyclone V Gx with Quartus 21.1 with adding and removing few IPs. The Design is not finished yet,...
FakhrulA_altera
Regular Contributor
Regular ContributorHi t_alars,
There are many factors can affect the estimated values displayed in the EPE spreadsheet, it is worth for you to check this document: Early Power Estimator User Guide on page 44.
Are you using the EPE downloaded from this page?- Cyclone® IV and Cyclone® V Device Early Power Estimator
Regards,
Fakhrul
t_alarsHello @Fakhrul,
Ja, I used the EPE you mentioned, and I also read the document about EPE and followed exactly the training course from Intel about using EPE.
However, I am not sure if this is correct results or at least close to the estimated results.
@Fakhrul Please, can you check my results in my post and see if they are close to real expected results or are they far from correct, and I can't count on them?
Best regards,
Taha
